For controlling and monitoring an automated lubrication system.

Model: 24N468   Not approved for outdoor use or use in explosive atmospheres or hazardous locations.  
 

Model: 24N468
Important Safety Instructions
Read all warnings and instructions in this manual. Save these instructions.
 

Warnings

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to Procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
 

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

• Do not operate the unit when fatigued or under the influence of drugs or alcohol.

• Do not exceed the maximum working Pressure or temperature rating of the lowest rated system com-ponent. See Technical Data in all equipment manuals.

• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

• Do not leave the work area while equipment is energized or under pressure.

• Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

• Check equipment daily. Repair or replace worn or damaged parts immediay with genuine manu-facturer’s replacement parts only.

• Do not alter or modify equipment. Alterations or modifications may void agency approvals and create safety hazards.

• Make sure all equipment is rated and approved for the environment in which you are using it.

• Use equipment only for its intended purpose. Call your distributor for information.

• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

• Do not kink or over bend hoses or use hoses to pull equipment.

• Keep children and animals away from work area.

• Comply with all applicable safety regulations.

Display (E)

• A blinking field on the display indicates the controller is in SETUP MODE.

• In RUN MODE numbers on the display will not blink.

Alarm LED (F)

Illuminates when any alarm is detected. When an alarm is active an error code displays and an audible alarm also sounds.

RIGHT Direction Arrow / MANUAL RUN /

ENTER (G)

• In SETUP MODE, saves entry, moves cursor in display one field to the right or to the next setup step.

• In RUN MODE activates the pump for one com-plete ON cycle if actuated during the OFF por-tion of the RUN cycle.

UP and DOWN Direction Arrows (H)

• Press and hold both the UP and DOWN Arrow keys together for 3 seconds to enter SETUP MODE.

• In SETUP MODE increase or decrease number values associated with the various RUN

MODES.

LEFT Direction Arrow / RESET (J)

• In SETUP MODE moves cursor in display one field to the left.

• In RUN MODE, Pressing RESET starts a PUMP OFF cycle.

• In ALARM MODE, Press once to clear buzzer; Press and hold for 3 seconds to clear warning and switch controller to OFF MODE.

Pump ON LEDs (A, B, C)

1. Pressure Control LED: In RUN MODE illuminates indicating function mode that is currently running.

1. Cycle Control LED: In RUN MODE illuminates indicating function mode that is currently running.

1. Time Control LED: In RUN MODE illuminates indicating function mode that is currently running.

Pump OFF LED (D)

• In RUN MODE this LED illuminates when in the OFF or RESET portion of the RUN CYCLE.